EIGRP-Routing

For EIGRP Configuration We take two router Serise Cisco 2800.

and We Assume that the both router are initially configured.

now login in Router with Hyperterminal from PC.

now Create Consol Terminal with command

  Router_1(Conf-t)#Line consol 0

  Router_1(Conf-t)#Password Cisco

  Router_1(Conf-t)#Login

Now Create  Telnet for Virtual Enter in Router Or remoter logging.woth command

   Router_1(Conf-t)# Line vty 0 4

   Router_1(Conf-t)#Password Cisco

   Router_1(Conf-t)#Login



Now Go to the Ethernet port with command

    Router_1(Conf-t)#int Fa0/0

Give ip address with command

    Router_1(Conf-t)#ip Address "10.10.11.1 255.255.255.0 "

For Interface Up give command


  Router_1(Conf-t)#no shut

Now Go to the SErial port with command

    Router_1(Conf-t)#Serial 0/0

Give ip address with command

    Router_1(Conf-t)#ip Address "10.10.12.1 255.255.255.0 "

For Interface Up give command

  Router_1(Conf-t)#no shut

  Router_1(Conf-t)#Exit // Exit from interface

Ok,Now it's time to Enable  Protocol.

    Router_1(Conf-t)#Router eigrp 10

    Router_1(Conf-t)#network 10.10.11.1

    Router_1(Conf-t)#network 10.10.12.1

  Then save Configuration with command 'wr' Or Copy Runing_config to star_config


Do same Configuration in Router_2,But Give ip to these Seriese

  Router_2 Fast ethernet Ip:10.10.13.1/24

  Router_2 Fast Serial Ip:10.10.12.2/24


 Ok,Now it's time to Enable RIP Protocol.

   Router_1(Conf-t)#Router eigrp 10

   Router_1(Conf-t)#network 10.10.13.1

   Router_1(Conf-t)#network 10.10.12.1

Posted in: Lab's